SSworxs Front Support Diffuser Bracket
REVISED *** NOW with Mounting holes for Diffuser Rods As show on the Race Car FD3S !
SSworxs RX7 FD3S
Fitment :All years USDM/EURO/JDM chassis alike.
Key Points- Track tested on KRC Osaka 1000Hp track RX7 from Japan for years with flawless results and FINALLY available to the end user YOU .
Please note the unit in the Picture is a solid thick gauge Dimple Die Unit light weight YET STRONG to hold you front bumper ( V mount or Slant Mount Inter-cooler fitment only ) Also works with V8 swap FD3S ! Will NOT work with Front Mount inter cooler unless you run a small inter-cooler lower then our Products mounting zone.
Bolt-on Unit take takes only a few minutes to install .
inlucde mouting hardware